I have been able to connect a Panasonic V520 camcorder composite output via Hauppauge HVR1900 USB, but I can't see the sound part in iSpy.
When I use WinTV which is needed to setup Hauppauge HVR1900 and I view the camera there the sound works.
In Netcam Studio there is an option under the sound inputs named Camera Sound and as a result Hauppauge HVR1900 comes up as the sound driver. The driver used there is MainConcept (broadcast)AVC. I've tried using a small USB sound card (the little green one) but the volume is too high and doesn't allow further reduction in settings other than by an inline volume control, whereas where the Hauppauge HVR1900 sound is recognised it's fine
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests